Model Number: AUX-Ford-1
Brand Name: Wiiki-Tech
Key Specifications/Special Features:
Vehicle applications:FORDEdge 2007-2010Expedition 2007-2009Explorer 2006-2009
F-150 2004-2008
F-250 2005-2009
F-350 2005-2009
F-550 2005-2009
Focus 2005-2007
Freestyle 2005-2007
Fusion 2006-2009
Mustang 2005-2009
Sport Trac 2007-2009
LINCOLN
Mark LT 2006-2008
MKX 2007-2009
Navigator 2007-2009
Zephyr 2006
Mercury
Milan 2006-2009
Mountaineer 2006-2009
Installation instructions:
- Disconnect the negative battery terminal
- Remove the Ford radio to gain access to the connectors on the back of the radio
- Remove any connector that may be in the 16-pin data port
- Plug the 16-pin connector of the AAI-FD4 into the 16-pin Data port of the Ford radio
- Reconnect the factory 16-pin data cable (if present) into the mating socket on the AAI-FD4 (see note on back)
- Connect back/green wire of AAI-FD4 to ground (vehicle chassis)
- Connect gray/violet wire of the AAI-FD4 to a constant +12 volt source
- Connect appropriate length patch cord (not included) between the AAI-FD4 and auxiliary device
- Rotate the input sensitivity adjustment pot of the AAI-FD4 to its full clockwise position (minimum level)
- Re-install factory radio
- Reconnect the negative battery terminal
Install it right with AAI-FD4:
- Do not force connectors together as pin damage may occur
- This installation will be flawless if you take your time making the connections described below
- Following the installation sequence below is critical to ensure proper recognition of the auxiliary device by the factory radio
General overview:
- AAI-FD4 converts the rear seat entertainment port of specified OEM Ford/Lincoln/mercury can-bus radios to RCA level audio
- Input: AAI-FD4 features built-in audio adjustment circuitry with a 0 to +20 dB input sensitivity range of 0.475 to 4.75 volts (peak to peak)
- Allowing the installer to match the audio level of the AUX device to the audio level of the AM, FM, or CD modes of the factory radio
Verify operations:
- With radio on, activate auxiliary device
- Set volume on auxiliary device to preferred listening level
- Push the aux button on radio to gain access to auxiliary audio input
- Display on radio will show DVD/CD for a few seconds, then will display PAC HI-FI
- Verify that audio of auxiliary device is heard
- Rotate the input sensitivity adjustment pot of the AAI-FD4 counter-clockwise until volume level of auxiliary device matches that of AM, FM, or CD modes
By certification [File Integrity]
